Dslmodem > D-Link > DSL-G804V ADSL Geek
Rating: 2.5/5 Stars.(3 votes)
D-Link DSL-G804V information:

Available DSL-G804V Resources
DSL-G804V User Guide (Full Manual)
DSL-G804V Product Page
Modem/Router Features
Discontinued
Wireless Compatible
ADSL2/2+ Compatible
ADSL LAN Or Switch
How to login
- Go to http://192.168.1.1/ in your web browser and it should prompt you to login.
- The default username is admin
- The default password is admin
How to add PPPoA connection
Click on WANVPI = 0, VCI=100
WAN setting : PPPoA (RFC 2364)
Enter your username and password
Change 'Authentication protocol' to 'PAP'
Change 'Connection' to 'Always on'
Click on Apply, then click on 'Tools' (top), 'System' (left), then make sure under the 'Reboot Device' setting you tick 'Current settings' then click on the 'Reboot' button.
Missing DSL-G804V Resources
- Do you have these resources? Click below to add
- Quick Setup Guide
- Drivers
- Emulator
- Port Forwarding
- Telepermit Number
- ADSL Status Info
PWR+® POWER CORD FOR D-LINK DSL-G624M DSL-G624T DSL-G804V DVA-G3340S DVG-1402S
| US $11.90 End Date: Wednesday May-30-2012 14:22:40 PDT Buy It Now for only: US $11.90 Buy it now | Add to watch list |
New D-LINK DSL-G804V Wireless ADSL+Secuity w VPN Router 4-Port Switch Firewall
| US $29.98 End Date: Saturday Jun-09-2012 14:00:53 PDT Buy It Now for only: US $29.98 Buy it now | Add to watch list |
Keywords: Dslmodem D-Link DSL-G804V, 804v D-Link DSL-G804V dsl g804 g804
Page Views: 242
D-Link - ADSLGeek comments:
Fairly good, common, cheap routers, with a decent amount of features. (Note DSL200 is very poor) Xtra have put a customised interface onto some of the D-link routers, but still fine to setup for any ISP.
D-Link DSL-G804V - ADSLGeek Comments
ADSLGeek has not yet commented on this modem.
D-Link DSL-G804V - Customer Comments:
Add your own comments
Product Warnings
FIRMWARE RELEASE NOTES:
DSL-G804V Firmware release Note
Firmware: 1.00.08.dm8
Hardware: A1, B1
Problems resolved:
1. Added multiple PPPoE session support.
2. Added ADSL status page.
3. Made adjustments of Date and Time.
4. The maximum number of Inbound Throttling rules is limited to 10.
5. The maximum number of Outbound Throttling rules is limited to 10.
6. Error Message when creating IP Alias on the LAN-interface (fixed)
=========================================================
DSL-G804V Firmware release Note
Firmware: 1.00.08.dm2
Hardware: A1, B1
Problems resolved:
1. Outbound Throttling issue (fixed)
=========================================================
DSL-G804V Firmware release notes
Firmware: 1.00.08.dt1
Hardware: A1, B1
Problems resolved:
1. Some Inbound/Outbound issues
=========================================================
DSL-G804V Firmware release note
Firmware: 1.00.08.ds1
Hardware: A1, B1
Problems resolved:
1. Wireless issue with FS LOOX420 and LOOX720 laptops, OS: Windows Mobile 2003 2003SE (fixed)
2. Throttling issue (fixed)
==========================================================
DSL-G804V Firmware Release Note
Firmware: 1.00.05.dg3
Hardware: A1, B1
Date: Nov. 29, 2006
Problems resolved:
1. PPTP disconnect when enable "Active as Default Route"
Enhancements:
===========================================================
DSL-G804V Firmware Release Note
Firmware: 1.00.05.ds2
Hardware: A1, B1
Date: Nov. 10, 2006
Problems Resolved:
1. Fixed IPSec through WiFi.
2. Fixed PPPoE issue.
3. Fixed Multicast and WiFi devices issue.
Enhancements:
============================================================
DSL-G804V Firmware Release Note
Firmware: 1.00.04.dm4
Hardware: A1
Date: Mar. 01, 2006
Problems Resolved:
1. Fixed IPSec compatible issue with D-Link VPN Client Software.
Enhancements:
===========================================================
Firmware: 1.00.04.dm3
Hardware: A1
Date: Feb. 24, 2006
Problems Resolved:
1. Fixed wireless security page display issue.
2. Fixed “Edit” button link error of VLAN Bridge setting.
Enhancements:
===========================================================
Firmware: 1.00.04.dm2
Hardware: A1
Date: Feb. 22, 2006
Problems Resolved:
1. Fixed SSID and Channel ID setting error.
Enhancements:
===========================================================
Firmware: 1.00.04.dm1
Hardware: A1
Date: Feb. 10, 2006
Problems Resolved:
1. Fixed bug when choosing VPN dialin, the option Active as default route can’t be used in the PPTP/L2TP webpage.
2. Fixed bug where the bugger for event log entries (REGISTER) was too short.
3. Fixed bug to remove Reserved Mapping rule with multiple NAT setting.
4. Fixed DNS memory leak issue.
5. Fixed SNMP community factory default settings error.
6. Fixed system crash issue when PPPoE/PPPoA/PPTP/L2TP connection is broken unmorally during data transmission
7. Fixed some brands of wireless client cannot get an IP address when using WPA-PSK and DHCP server is enabled.
8. Fixed PPP encapsulation losing memory when “connect on demand” mode is selected.
9. Fixed system crashes when WAN and LAN IP overlapped caused by WAN change to RFC1483 bridge mode.
10. Fixed DHCP Relay over IPSec tunnelling.
11. Fixed system lock from DNS relay query through TCP port 53.
12. Fixed IPSec packet can not pass MTU size.
13. Fixed bug of VLAN setting.
Enhancements:
3. Minimum length of 8 characters for a WPA Pre-Shared Key is now enforced when key is entered via web interface.
4. The configuration can be saved when Remote Access set to always on (0 seconds).
5. Added protection that prevents Passphrase being used when WEP encryption mode is ASCII.
6. Make NAT outgoing mapping IP as fixed as WAN IP when set global IP pool in Virtual Server. It’s random to map different IP in IP pool in old version.
7. Modified Ralink’s WPA key length from 32 to 64.
8. Modified memory size to solve restoring issue when configuration file is too big.
9.
===========================================================
Firmware: 1.00.03.rc2
Hardware: A1
Date: Jan. 24, 2006
Problems Resolved:
Enhancements:
10. Update DSP code to E67.2.12. Annex A+M supported. The hardware version A1 doesn’t support Annex M.
===========================================================
Firmware: 1.00.03.rc1
Hardware: A1
Date: Dec. 08, 2005
Problems Resolved:
1. Fixed PC cannot get IP address when using WPA-PSK with some brands of wireless client card.
2. Change WEP Key display number from (0~3) to (1~4)
3. Fixed bug show the correct name of field on the IPSec setting page.
4. Forced ADSL connection mode to ADSL2+ and it’s auto fallback to ADSL.
Enhancements:
11. Firmware can support Annex M, but depends on hardware support. The hardware version A1 doesn’t support Annex M.
===========================================================
Firmware: 1.00.02.dm1
Hardware: A1
Date: Sep. 30, 2005
Problems Resolved:
1. Fixed system crash when WAN IP subnet is overlay to LAN IP subnet.
2. Fixed multicast packet doesn't forward to wireless interface. IGMP snooping must be enabled for IGMP forward.
3. Fixed bug were virtual Server and URL Filter were accepting incorrect IP address when firewall was enabled.
4. Fixed the Virtual Server rule being deleted when changing protocol.
5. Fixed MSN ALG and SIP ALG to prevent confusion with UPnP.
6. Fixed the bug "IPSec : when you choose "AH", the "Encryption" should be disabled."
7. Fixed the bug "IPSec : when you choose "AH", the default authentication type should be "None", not "MD5"
8. Fixed the bug "IPSec : AH/Authentication..=> When you "apply" the settings, the VPN/IPSec List is always "SHA1". It can't show "MD5" or “None"
9. Fixed to display the One-to-one NAT Table.
10. Fixed MAIL LED display error.
11. Fixed ITO problem with Cisco (Peer ID Payload in Phase 2: protocol/port = 17/0)
12. Fixed router hanging issue when performing VoIP quality test with TestYourVoIP.com website or similar websites.
13. Fixed a configuration error when configuration One-to-one NAT to DMZ zone type.
14. Fixed various web interface bugs to allow several Candidates selection lists to work with Firefox.
15. Fixed exception IP bug in the URL Filtering.
Enhancements:
1. WPA2 supported.
2. Support VLAN and multiple PVC WEB configurations.
3. Integrate customization for both EU and AU.
4. Updated ADSL DMT code to E.38.3.12 for improving ADSL2/2+ interoperability with Annex A modem
5. Wireless driver can auto-detect INPROCOM and Ralink module.
6. Add 3 DDNS server “dyndns.adept.co.za”, “www.dtdns.com” and “vdyn.b2e.co.za”, and removed www.orgdns.org.
=============================================================
Search/Other Info
- Search Google
- Search News Groups
DSL-G804V - 4 Port Wireless ADSL Modem/Router with VPN